LG UJ30.NV2R0 Uživatelský manuál

www.lg.comPlease read this installation manual completely before installing the product.Installation work must be performed in accordance with the nat

Installation Flaring WorkMain cause for gas leakage is due to defect of flaring work. Carry out correct flaring work in thefollowing procedure.Cut t

InstallationCheck1. Compare the flared work with the figure by.2. If a flared section is defective, cut it off anddo flaring work again.InclinedInside

InstallationConnecting the Piping1. Open the panel of the indoor unit.2. Remove the chassis cover from the unit by loosing 5 screws.3. Pull back the t

InstallationInstallation Information. For right piping. Follow the instruction below.Good case• Press on the tubing cover and unfold the tubing to do

InstallationIf the drain hose is routed inside the room insulate the hose with an insulation material* so thatdripping from sweating (condensation) wi

InstallationWrap the insulation material around theconnecting portion.1. Overlap the connection pipe insulationmaterial and the indoor unit pipe insul

Installation Checking the DrainageTo check the drainage.1. Pour a glass of water on the evaporator.2. Ensure the water flows through the drainhose o

Installation 1. Check that all tubing and wiring are properly connected.2. Check that the gas and liquid side service valves are fully open.Prepare

18 Air Conditioner

After reading this manual, keep it in a place easily accessible to the user forfuture reference.

2 Air ConditionerRoom Air Conditioner Installation ManualCONTENTSSafety Precautions ...3Introduction ...

Installation Manual 3Safety Precautions To prevent the injury of the user or other people and property damage, the following instructionsmust be fo

Safety Precautions Do not install the product at a place that thereis concern of falling down.• Otherwise, it may result in personal injury.Use caut

Safety Precautions n InstallationInstall the drain hose to ensure that draincan be securely done.• Otherwise, it may cause water leakage.Install

6 Air ConditionerIntroduction This symbol alerts you to the risk of electric shock. This symbol alerts you to hazards that may c

Figure FigureNameScrew driverElectric drillMeasuring tape, KnifeHole core drillSpannerTorque wrenchMulti-meterHexagonal wrenchAmmeterGas-leak detector

8 Air ConditionerInstallationIndoor unit1. There should not be any heat or steam nearthe unit.2. Select a place where there are no obstaclesaround of

Installation Manual 9Indoor unit1. Mount the installation plate on the wall withtype "A" screws. If mounting the unit on aconcrete wall, us