LG LSN5AP2D Uživatelský manuál stáhnout pdf (Strana 28)

Tip of drain hose

dipped in water

Water

leakage

Ditch

Less than

50mm gap

Checking the drainage

Do not make drain piping.

Form the piping

Do not raise

Water

leakage

Accumulated

drain water

Air

Waving

Water

leakage

Taping

Drain

hose

Pipings

Connecting

cable

A

Form the piping by wrapping the

connecting portion of the indoor unit with

insulation material and secure it with two

kinds of vinyl tapes.

If you want to connect an additional drain

hose, the end of the drain outlet should be

routed above the ground. Secure the drain

hose appropriately.

B

In cases where the outdoor unit is

installed below the indoor unit perform

the following.

Tape the piping, drain hose and

connecting cable from down to up.

Secure the tapped piping along the exterior

wall using saddle or equivalent.

C

In cases where the Outdoor unit is

installed above the Indoor unit perform

the following.

Tape the piping, and connecting cable from

down to up.

Secure the taped piping along the exterior

wall. Form a trap to prevent water entering

the room.

Fix the piping onto the wall by saddle or

equivalent.

Seal small openings

around pipings with a

gum type sealant.

Trap is required to prevent water

from entering into electrical parts.

Seal a small opening

around the pipings

with gum type sealant.

Trap

Trap

Downward slope

A

To remove the front panel from the indoor

unit cabinet.

Set the air direction of louvers up-and-down to

the position(horizontally) by hand.

Remove the securing screws that retain the

front panel. Pull the lower left and right

sides of the grille toward you and lift it off.

(1TR, 1.5TR, 2TR)

B

To check the drainage.

Pour a glass of water on the evaporator.

Ensure the water flows through the drain

hose of the indoor unit without any leakage

and goes out the drain exit.

C

Drain piping

The drain hose should point downward for

easy drain flow.

Screw

Pull the right and

the left side.

CHECKING THE DRAINAGE AND FORMING THE PIPING

INSTALLATION

17

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Komentáře k této Příručce

Žádné komentáře