LG LD-14AT2 Uživatelský manuál stáhnout pdf (Strana 3)

5

INSTALLATION INSTRUCTION

4

INSTALLATION INSTRUCTION

Unit:mm

Step1:

PREPARE CUPBOARD OPENING

Step2:

PREPARE ELECTRICAL WIRING

1

2 3

4

This dishwasher is designed to fit to the

size shown as below.

Select a location as close to sink as

possible for easy connections to water and

drain lines.

The dishwasher should not be installed

more than 3 meters from sink for proper

drainage.

If dishwasher is to be installed in a corner,

a minimum 5cm of space is required

between the washer and an adjacent

cabinet or a wall.

1

2 3

This appliance must be supplied with

correct rating voltage and hertz as shown

on instruction manual, and connected to

an individual, properly grounded branch

circuit, protected by minimum 15 amp

circuit breaker or time delay fuse.

Wiring must be 2 wires with ground.

The power plug must be in a accessible

location adjacent to and not behind the

dishwasher and within 1.2 meters of the

dishwasher side.(See page 6 Fig.A)

The power plug must be correctly

earthed, if in doubt, have it checked by a

qualified Electrician. No other appliance

should be connected to the same plug

outlet by a double adapter or similar

plug.

CAUTION

For personal safety, remove house fuse or

open circuit breaker before installation. Do not

use an extension cord or adapter plug with

this appliance. Electrical and grounding

connections must comply with the national

electrical code/provincial and municipal code

and/or other local codes.

If bare chipboard is adjacent to or above the

dishwasher, it should be sealed with a

waterproofing paint or sealant to prevent

swelling due to steam.

Step3:

PREPARE DISHWASHER FOR

INSTALLATION

1

2

Lay the dishwasher on its back.

Adjust the legs to the needed height of

cabinet as shown in below figure.

Step4:

INSTALL THE DISHWASHER IN

CUPBOARD

1

2

Before sliding the dishwasher into the

cupboard opening, all necessary final

height adjustment and balancing

adjustment should be done using the

spanner.

Slide the dishwasher into the cabinet

opening carefully. Make sure that the

drain hose inside the cabinet is not

kinked or stretched.

CAUTION

If the height of cupboard is below 850mm, you

should remove the top table by unscrewing

the 2 screws. (Two of rear)

1 2 3 4 5 6 7 8 9 10

Komentáře k této Příručce

Žádné komentáře