LG LD-14AT2 Uživatelský manuál stáhnout pdf (Strana 4)

7

INSTALLATION INSTRUCTION

6

INSTALLATION INSTRUCTION

Step5:

DRAIN LINE CONNECTION

1

2

If the end of drain hose does not fit to

the drain line, use a piece of rubber

connector(not supplied) that must be

resistant to heat and detergent and may

be obtained from a plumbing shop.

There are 2 typical connections as

shown in Figure A, B.

The "S" trap spigot must be drilled out

cleanly and free of obstruction to its

maximum internal diameter, if used for

drainage.

To prevent siphoning, one of the following

instruction methods must be followed:

When the drain hose is connected to a

sink "s" trap or waste disposal unit, the

hose must be looped up to the underside

of the bench top and secured.

When the drain hose is connected to a

separate stand pipe, it is essential that an

air tight connection is made.

Refer to Fig.B

Drain Hose Extension

Extend Drain Hose as shown below.

Fig. A

Fig. B : Drainage connection - stand pipe.

CAUTION

When you connect or extend Drain Hose,

make sure that drain hose is not kinked.

(Bends should have 40 mm radius.)

SW

1

2

Step7:

FINAL CHECK AND

ASSEMBLING

1

2

Securely hand tighten supply hose to

water supply.

Plug power supply cord into an

earthed the power plug and switch on.

Operate the dishwasher through one

cycle (Quick cycle is recommended)

to check for water leak and operating

conditions.

Step8:

HOW TO LEVEL THE PRODUCT

After installing the product, if you feel some

sticky or hear a frictional sound between the

side portion of door and tub when you open or

close the door, you have to adjust the level of

product.

? If the door is slanted to the right as shown in

figure C, repeat the procedure shown as

below until the door is operated normally.

1) Unscrew(counter-clockwise) the left leg of

back side and high the level.

2) Check the opening of door if there still

remains sticky or friction sound.

? When the product is correctly leveled, there

do not remain slant, stickiness or a friction

sound.

? If the door is slanted to the left as shown in

figure D, repeat the procedure shown as

below until the door is operated normally.

1) Unscrew(counter-clockwise) the right leg

of back side and high the level.

2) Check the opening of door if there still

remains sticky or friction sound.

? When the product is correctly leveled, there

do not remain slant, stickiness or a friction

sound.

S

Fig. C

Fig. D

Case 1. In case the door is slanted to the right

Case 2. In case the door is slanted to the left

Step6:

WATER SUPPLY CONNECTION

1

2

Connect the water supply hose to the

valve behind dishwasher and the water

tap as shown in figure.

This dishwasher may be fed with either

hot or cold water. If the water can not be

maintained below 65ºC, the dishwasher

must be connected to cold water.

When connecting, the sealing tape or

sealing compound should be used to

avoid water leaks.

Make sure that the line is not kinked or

sharply bent.

Water tap

Water supply

hose

Valve

1 2 3 4 5 6 7 8 9 10

Komentáře k této Příručce

Žádné komentáře